Step By Step
Start by making sure your target area is clean and dry, and that the hair is 1 to 2mm long.
Cover the area with a layer of No Grow about the same thickness of a credit card. Leave for the prescribed amount of time.
Use the provided towel tabs to gently scrape off excess product, then wash and rinse the area to fully neutralise.
Trim the hair in the area to be treated to approximately 1mm-2mm in length, this will ensure that the active ingredients in No Grow can better adhere to the hair shaft and neutralize the root. Shortened hair will also reduce wastage of product.
Before applying No Grow make sure that the area you are treating is clean of any surface oils, creams, lotions or serums to allow optimum penetration of the active ingredients.
Dispense a small amount of the cream onto your fingertips and smooth a thin but visible layer onto the skin, do not rub in.
Wash hands immediately.
Leave No Grow on the skin for the prescribed amount of time.*
Remember that after that time the active ingredients have done their job by travelling to the root of the hair, via the hair shaft, therefore leaving the product on the skin for longer will have no added benefit.
After No Grow has been applied and left on the skin for the prescribed amount of time, use the provided towel tabs to wipe off any excess product and then remove any remaining cream with a damp cloth, rubbing gently in a circular motion. Follow by rinsing the area with water to fully neutralise and dab dry using a towel or cloth.
Apply No Grow Soothing Aftercare Gel at this point, the soothing gel is left on the skin.
DO NOT apply any creams, serums or lotions containing actives ingredients like Vitamin A and Vitamin C after application.
If you feel the necessity to shave after application, we suggest that you apply the No Grow Product in the evening, and that you shave the next morning.
*Facial area - 5-10 minutes.
*Intimate area - 10-15 minutes.
*Body area - 15-20 minutes.